OBJECTIVE

The objective of BeetleRun is to keep the beetle running as long as
possible before it reaches a dead end.


GAME PLAY

At the beginning of the game there is a game board filled with
different shaped passageways. At the right side of the screen there
is a beetle which will move towards the top right hole. Once the
beetle reaches the hole, it will appear on the board from the grid
marked START. Using the cursor and the A and B buttons, you can
rotate any grid clockwise (B) and counterclockwise (A). Your
objective is to create a continuous path for the beetle to crawl
through. For the first seconds you can also rotate the START grid,
yet once the beetle emerges from it, it will remain stationary.


RESET AND INCHES CRAWLED

As the beetle moves through the tunnels, they will turn yellow and
you will not be able to use them again. The only exception is the
crossing path grid which can be used more than once. You can have
the beetle go off the board in any direction. It will then appear from
the opposite side. On the right side of the screen there is an inch
meter. This measures the distance the beetle has traveled. If you can
get the beetle to travel 20 inches and can reach one of the sides of
the board, (providing the entrance on the other side is open) then
the grids which were yellow will now reset themselves and you can
continue to keep the beetle moving by rotating the grids. Every time
that you are able to reset the board, a single black grid will appear
which can never be removed. The starting gate, if present on the
board, will now be removed and a passageway grid will take its place.



FAST BUTTON

The Y button is the fast button. If you press the fast button while the
beetle is on the game board, then the beetle will speed through the
tunnels at a much faster rate. Once the beetle reaches the sides of the
board and reappears on the other side, it will automatically slow down
again.  This fast button is very important because when the beetle is
running in fast mode, you get double the points for the distance it
travels. If you have set up a long series of tunnels that go off and on
the board, then use the fast key to get more points.


SCORING

There is a score needed total shown at the bottom of the screen. In
order to proceed to the next level you must reach or surpass this point
total in order to continue the game. If you don't reach this point total
by the time your beetle reaches a dead end, then the game will be over.
The points needed for each level is determined by this formula:

             100 + (10 * LEVEL) + (plus previous score)

4 Points are scored for each passageway it takes through the tunnels.
An extra 3 points are given every time you can get the beetle to exit
the board and re-enter it. These will be stored in the Bonus Point
total, and will be added to your score at the end of the level.

There are also green bonus tunnels which will sometimes appear on
the board. If you can get the beetle through these, you will earn 20
extra bonus points.


MULTIPLE STARTING GATES

On the higher levels, the game board might contain more then one
starting grid. You will not know which start grid the beetle will
emerge from, so you'll have to plan ahead for each starting grid.


ENDING GRID

On some levels there will also be a red ending grid. This means
you must get the beetle to end in this grid or the game will be over
no matter how many points you score for that level. This ending grid
can be rotated even after the beetle starts to move on the game board.

* REMEMBER WHEN YOU SEE A RED ENDING GRID, YOU MUST END THE BEETLE
  THERE OR THE GAME WILL BE OVER NO MATTER HOW MANY POINTS YOU
  SCORED FOR THAT LEVEL.


BUTTONS

PAD           :   Move the cursor
A             :   Rotate counterclockwise
B             :   Rotate clockwise
Y             :   Speed beetle through the maze for double points!
START         :   Pause
L + R + START :   Quit Game